Washing Machine Leaking From Bottom? Check When It Happens

If your washing machine is leaking from the bottom, stop the cycle. If water is near the plug or outlet, or you would have to stand in water to reach it, leave the plug alone and switch off the circuit breaker first. Then turn off both water faucets and dry the floor. Check the hose connections and the drain standpipe before testing the washer again.

If those areas are dry and it is safe to test, turn the water back on and run an empty cycle while watching when the leak appears: during fill, wash, drain or spin. If the leak returns with no visible outside source, stop using the washer and book service.

When the water appearsCheck first
While fillingHose connections at the back and their rubber washers. On a front-load, the detergent drawer.
While washingFront-load: the door gasket and suds. Top-load: overloading and water splashing over the top.
While drainingThe drain hose and standpipe. On a front-load, check the accessible pump-filter cap too.
While spinningOverflow at the standpipe first, then level, load size and suds.
While the washer is offSupply hoses and faucets. If water is entering the tub, book service.
Table of Contents

Is the Water Really Coming From the Washer?

Rule out these look-alikes before you test anything:

  • Normal drops. A few drops inside a front-loader’s door after a wash are leftover moisture from the spin. On Samsung, water that drips when you open the door is normal. It is a leak if water escapes while the door is closed.
  • Drain overflow. Water backing up at the standpipe or wall box is often mistaken for a washer leak. If that is what you see, use our Washing Machine Drain Clogged? Check These 3 Places guide.
  • A leaking faucet or wall valve. If the water starts there, it is a plumbing problem, not a washer repair.

On an uneven floor, a leak at the back can show up at the front, so dry the whole area and look for where the water first appears.

Rear view of a washing machine showing fill hose connections, drain hose, standpipe, and water on the floor

Run an Empty Test Cycle

If the outside is dry, turn the water back on, put a towel on the floor and run a short cycle with no clothes and no detergent. Watch the washer and note when the water appears. If water is pouring out rather than dripping, skip the test, keep the water off and book service.

If it stays dry, check the load size, suds, splashing and washer level before looking for an internal fault. If it leaks with the tub empty, use the timing below to locate the source.

When Does Your Washing Machine Leak From the Bottom?

While Filling

Check the hose connections at the back first. With the faucets off, look for wetness at both ends of each fill hose. Make sure a rubber washer sits inside each hose end, and tighten any loose connection. Replace a worn washer or a cracked hose.

If water still seeps where the hose meets the wall valve after you replace the hose, call a plumber.

On a front-load, water at the detergent drawer points to buildup in the drawer or too much detergent. Clean the drawer and use less.

If the hose connections and the drawer are dry, move to the timing that matches when the leak appears.

While Washing

On a front-load, check the door gasket. Fold it back and clear hair, lint and thread from the folds. A torn gasket needs replacing, so book service.

On a top-load, don’t pack the tub. On LG top-loaders, the clothes should stay below the top row of holes in the drum. Pillows and duvets can float and splash water over the top.

On either type, too many suds can cause water to leak out. Use HE detergent and follow the detergent and washer instructions for the amount. If your dispenser has a MAX line, don’t exceed it. If you see heavy suds, run an empty cycle with no detergent until they stop.

While Draining

Check the drain hose first. Look for kinks, cracks and a connection that has slipped out of the standpipe. A cracked or damaged drain hose needs service.

On a front-loader with an accessible pump filter, make sure the drain-hose cap and pump filter are fully reseated as your manual shows, and don’t overtighten the filter.

If water is still trapped in the washer, use our Clothes Washer Won’t Drain? Check These Clues First guide before opening the filter.

Before opening the filter, turn the washer off and disconnect power. If the floor is wet, use the circuit breaker instead of reaching for the plug.

While Spinning

Watch the standpipe during the spin. If water backs up and overflows there, the problem is the drain, not the washer. See the drain-overflow section above.

If the washer is also shaking or walking during the spin cycle, see our [Washing Machine Shaking Violently? Check the Load and Feet First] guide.

If the standpipe is fine, check that the washer is level. Rock it gently. It should sit firmly on all four corners. Adjust the feet if it moves, then recheck the load size and detergent.

If the standpipe, drain hose, washer level, load and suds are all ruled out and it still leaks during spin, stop testing and book service.

When the Washer Is Off

If the washer leaks while it is off, start with two checks:

  • Water on the floor, tub not filling. Check the supply hoses and faucets as described under While Filling.
  • Water entering the tub. Turn off both faucets and book service. Water entering the tub while the washer is off points to the water inlet valve, which is a service job.

Brand Notes

BrandWhat changes the fix
SamsungClean the front-load pump filter once a month or every 40 washes, whichever comes first.
LGA front-load can leak from the safety air vent at the back when there are too many suds. Use HE detergent, reduce the amount and run Tub Clean. If it still leaks after three Tub Clean cycles in a row, book service.
Whirlpool“No-splash” or “easy-pour” liquid chlorine bleach can create excess suds, so switch to regular liquid bleach. If your model has a bulk dispenser at the base, make sure it is fully closed.
GEOn a front-load, put detergent pods in the drum with the clothes, not in the dispenser.

When to Stop and Book Service

Book service if any of these apply:

  • The door gasket is torn.
  • The drain hose is cracked, split or damaged.
  • It still leaks on an empty test cycle after the checks above.
  • Water enters the tub while the washer is off.
  • There is a puddle and you cannot find an outside source. Stop using the washer.

Call a plumber instead if the leak is at the faucet or wall valve, or if the standpipe overflows because the house drain is blocked.

Don’t tip the washer or open the cabinet to look for the source. If the leak is inside the washer, ask the technician for a repair quote before you decide whether to replace it.

For other washer problems, continue with our Washing Machine Troubleshooting guide.

Sources

Last reviewed: October 11, 2026