Washing machine making loud noise? Note when it happens before you decide what is wrong. Filling, washing, draining and spinning each have sounds that are normal. A bang or thump during spin usually means checking the load and the feet. Repeated rattling or clicking can come from a loose item or something touching the washer. A new or unusually loud grind or squeal can come from an overloaded drum. If the noise continues after the matching checks below, book service.
| When it happens | What you hear | First check |
|---|---|---|
| Filling | A pop, honk or beep as the valve opens | Usually nothing. Samsung lists it as normal. |
| Filling | Loud humming, buzzing or grinding, with little or no water | Whether the water supply valves are open |
| Washing | Grinding or squealing | Reduce the load, then try the towel test |
| Washing or spinning | Rattling or clicking | Loose items in the drum, then hoses or objects touching the washer |
| Draining | A quiet hum or buzz while water drains | Nothing. It is normal. |
| Draining | Grating or rattling every cycle | The pump filter, if your model has an accessible one |
| Spinning | Banging or thumping | The load, then the feet |
| Any time | A sound like a jet preparing for takeoff | Book service |
Table of Contents
Is It a Normal Washer Sound?
Manufacturers list these as normal:
- Filling. A pop, honk or beep as the water valve opens (Samsung). Spraying and sloshing on Maytag top-loaders.
- Draining. A quiet hum or buzz while water drains (Samsung and LG). GE adds a slurping or gurgling at the end of draining on its GTW460, GTW485, GTW490, GTW680 and GTW750 top-loaders.
- Switching modes. A click followed by a short thump when the washer moves from washing to spinning (Samsung), a clunk as the drive shifts between agitation and spin (Maytag top-loaders), or a knock when it goes from a pause to spin (GE).
- Motor sounds. The motor reversing and some gear sounds during washing and spinning (Whirlpool). On certain GE top-loaders (GTW460, GTW485, GTW490, GTW680 and GTW750, bought since September 2015), an electric hum or grinding while agitating.
- Cycle start and end. Some clicks (Samsung).
If your sound matches one of these for your type of washer and it is working normally, you don’t need to do anything.
Washing Machine Making Loud Noise During Spin
The drum turns fastest during spin, so an uneven load or a washer that isn’t level shows up most. Check in this order:
- The load. Pause the cycle and wait until the drum stops. Spread the laundry evenly. Bulky items like rugs and blankets can make the tub lopsided, according to LG. Samsung adds that a steady thump that follows the spin can be normal with large items such as bedsheets.
- The feet. Push the washer forward, backward and sideways. If it shakes, adjust the feet until all four press firmly on the floor.
- Shipping bolts, on front-loaders only. If the washer is new or was just moved, the bolts must be removed. Whirlpool says leaving them in can cause noise, vibration or error codes.
- A spin with the drum empty. LG says that on its top-loaders, a quiet spin with an empty tub means the washer is operating normally.
Samsung has a video on checking washer noise and vibration:
If the washer is also walking across the floor or shaking hard, use our Washing Machine Shaking Violently guide. It covers the feet, the floor and a test cycle in more detail.
Noise During Washing or Agitation
Grinding or squealing. Samsung says this is usually an overloaded drum. Stop the cycle and reduce the load, then try Samsung’s test: wash about four soaking-wet bath towels. If the noise is gone, avoiding overloads is enough. If it happens during the test, request service. Whirlpool says a grinding or rubbing noise can get louder if the washer isn’t level.
If a drain pan sits under your washer, the tub bottom may rub against it, especially with heavy loads. Whirlpool says to extend the leveling feet to their maximum height, check that the washer is level and check that the pan isn’t damaged.
Rattling or clicking. Look in the drum first. LG says to remove the laundry and look for items such as a coin or steel wire, and Maytag says to empty pockets before washing. On LG front-loaders, you can also remove the clothing and turn the drum by hand. If the noise continues, LG says the washer needs repair service.
Noise While Draining
A quiet hum is normal. If the noise is louder or harsher than a hum, check these two things:
- Unusually loud humming. LG says foreign objects stuck in the drain filter can make the pump sound loud. Check the drum for snagged items too.
- Grating, grinding or rattling. Samsung says this is the sound of the drain pump operating. If it happens every cycle, Samsung says to clean the pump filter, if your model has an accessible one.
Water spills when you open the filter, so have towels and a shallow container ready. Our Clothes Washer Won’t Drain guide covers the drain checks in order.
Noise While Filling
A loud hum, buzz or grind with little or no water coming in can mean the home water supply valve is closed, according to Samsung. Open the supply valves fully and check that the hoses are connected. If the washer still isn’t filling, use our Washing Machine Not Filling With Water guide.
Rattling, Clicking or Banging From Outside the Drum
Sometimes the noise isn’t inside the washer at all.
- Hoses. Whirlpool and Maytag say the drain hose or inlet hoses can knock against the back of the cabinet when the washer vibrates and water flows. Secure them with the beaded strap that comes with some models, or with a wire tie.
- Things leaning on the washer. Brooms, dustpans, dryer racks and hangers can rattle against it, especially at high spin speeds. LG adds that shelves or storage closets shouldn’t touch the washer while it runs.
- The power cord. Samsung lists the cord and the drain hose among the things that can hit the washer.
When to Stop and Book Service
Book service if any of these apply:
- The washer sounds like a jet preparing for takeoff. Samsung says this needs service.
- The noise happens during the towel test.
- The noise continues with the clothing removed and the drum turned by hand.
- Grating or rattling from the drain pump continues every cycle after you clean the filter.
- The noise continues after the load, feet, shipping bolt and outside checks.
If the washer is hitting something or moving hard, stop the cycle. Don’t open the cabinet to look for the cause. Tell the technician your model number, when the noise happens, what it sounds like and which checks you have done.
For other washer problems, continue with our Washing Machine Troubleshooting guide.
Sources
- Samsung US: Samsung washing machine is too noisy
- LG USA: Troubleshooting noises during the cycle
- LG USA: Front-load washer, humming noise during spinning
- LG USA: Top-load washer, noise when spinning
- Whirlpool Product Help: Banging noise, front-load washer
- Whirlpool Product Help: Grinding or rubbing noise, front-load washer
- Whirlpool Product Help: Bang or banging noise, top-load washer
- Whirlpool Product Help: Grinding or rubbing noise, top-load washer
- Maytag Product Help: Thumping noise, front-load washer
- Maytag Product Help: Knocking or thumping noise, top-load washer
- Maytag Product Help: Clunk or clunking noise during spin
- Maytag Product Help: Spraying, splashing or sloshing noise
- GE Appliances: Top load washer, normal sounds
- GE Appliances: Washer, knocking noise during agitation or spin cycle
Last reviewed: October 16, 2026