Washing machine not spinning? First check whether water is still in the washer. If water is standing in the tub or drum, start with our Clothes Washer Won’t Drain guide. If the washer drained but the clothes are still soaking wet, check that the door or lid is fully closed, spread the load evenly and check the spin setting. Some washers also pause for a few minutes before they spin. If the spin still never starts after those checks, book service.
| What you see | First check |
|---|---|
| Water is still in the tub or drum | The first section below |
| The washer drained but the clothes are soaking wet | The door or lid, then the spin setting and the load |
| It paused for a few minutes before spinning | Wait. GE says pauses of up to 3 minutes can be normal. |
The display shows bALAnCINg, or SPIN flashes | Spread the load evenly, then choose Drain & Spin (GE) |
| It spins slowly on Delicate or Hand Wash | Normal. Whirlpool says those cycles spin slower on purpose. |
| It shakes hard before it stops | Our Washing Machine Shaking Violently guide |
Table of Contents
Is There Still Water in the Tub or Drum?
Look through the door glass or down into the tub. Samsung says a washer tries to drain before it spins, and if it can’t drain, it never moves on to the spin step. So water left behind is a drain problem first and a spin problem second. Use our Clothes Washer Won’t Drain guide, which covers the drain checks in order.
Washing Machine Not Spinning After It Drains?
If your washing machine drains but won’t spin, and the clothes are still soaking wet, check these in order:
- The door or lid. The washer may not spin unless the lid or door is securely closed. GE says none of its top-loaders spin with the lid up, and that on its front-loaders the dispenser drawer must be fully closed too.
- The spin setting. A Low Spin or No Spin choice removes less water. On some Whirlpool front-loaders it can also be remembered from a previous cycle. Check the spin setting, then choose Drain & Spin. LG suggests a spin-only run at a high spin speed to see whether the drum turns.
- The load. An overloaded or uneven load can make the washer stop spinning to protect itself. Pause the cycle, wait for the drum to stop and spread the laundry evenly. A single bulky item or a very small load can throw it off balance too, and Samsung and GE both say to add a few similar items. If the washer shakes hard or walks during spin, use our Washing Machine Shaking Violently guide.
- Suds, on front-loaders. Too much detergent, or detergent that isn’t HE, can make suds that cut the spin speed or stop the washer from pumping and spinning, says Whirlpool. Use only HE detergent, in the amount your manual gives.
- Power. If the power went off during the cycle, the washer may not reach full spin speed, and GE says a loss of power can stop it spinning at all. Check the outlet and breaker, then choose Drain & Spin.
- Anything you can see in the drum. LG says coins, zippers or buttons can get trapped and interfere. Unplug the washer and remove only what you can see.
Samsung Care has a video showing common checks when a washer won’t spin:
GE Pauses and Display Messages
GE says pauses of up to 3 minutes can occur between cycles before spin begins, and pump-out can add about 3 more. Don’t advance the timer by hand during a pause after agitation, or you may skip the pump-out.
On GE top-loaders from 2015 on, bALAnCINg or a flashing SPIN means the load is uneven. Spread the laundry evenly, then press Start, or choose Drain & Spin and press Start. If CAnCELEd scrolls or the two right-most lights flash, choose Drain & Spin and press Start. If that doesn’t clear it, disconnect the power for 1 minute and reconnect it.
When to Stop and Book Service
Book service if any of these apply:
- The drum is empty, the door or lid is closed, the setting is right and the load is even, but it still won’t spin.
- It drains and the motor runs but the drum does not turn. GE says that needs service.
- A code or message returns after the steps above.
- You can’t remove an object you see in the drum without opening the washer.
LG says that if the drum will not spin after its checks, service is needed for a proper diagnosis. Don’t open the cabinet. Tell the technician your model number, whether the washer drained and any code on the display.
If the washer spins and drains but the laundry doesn’t move during the wash, use our Washing Machine Not Agitating guide.
For other washer problems, continue with our Washing Machine Troubleshooting guide.
Sources
- Whirlpool Product Help: Not spinning, top-load washer
- Whirlpool Product Help: Not spinning, front-load washer
- Whirlpool Product Help: Washer not draining or spinning, troubleshooting guide
- Samsung US: Washing machine does not spin at all
- Samsung US: Washing machine spins poorly
- GE Appliances: Top load washer, does not spin
- GE Appliances: Front load washer, does not spin
- LG USA: Drum does not spin
Last reviewed: October 17, 2026